Difference between revisions of "Direct load"

From CRIPTWiki
Jump to: navigation, search
Line 5: Line 5:
 
First, you need to finish editing your .hx network for presentation. So make whatever final change necessary and STOP TOUCHING it after you done saving it.  
 
First, you need to finish editing your .hx network for presentation. So make whatever final change necessary and STOP TOUCHING it after you done saving it.  
  
Then after that, you NEED to open the .hx file using an editor such as Notepad++ (if not installed, go hunt Tim down about it). When you open it up... it will look like [[File:Demo.pdf|this]].
+
Then after that, you NEED to open the .hx file using an editor such as Notepad++ (if not installed, go hunt Tim down about it). When you open it up... it will look like [[this|File:Demo.pdf]].

Revision as of 20:08, 27 August 2009

To direct load Amira in stereo mode, follow these steps:

Remember, you can allow Amira direct boot into Stereo mode on any computer but what I describe below are for the Shuttle

First, you need to finish editing your .hx network for presentation. So make whatever final change necessary and STOP TOUCHING it after you done saving it.

Then after that, you NEED to open the .hx file using an editor such as Notepad++ (if not installed, go hunt Tim down about it). When you open it up... it will look like File:Demo.pdf.