Direct load

From CRIPTWiki
Revision as of 20:13, 27 August 2009 by Dyt811 (Talk | contribs)

Jump to: navigation, search

To direct load Amira in stereo mode, follow these steps:

Remember, you can allow Amira direct boot into Stereo mode on any computer but what I describe below are for the Shuttle

First, you need to finish editing your .hx network for presentation. So make whatever final change necessary and STOP TOUCHING it after you done saving it.

Then after that, you NEED to open the .hx file using an editor such as Notepad++ (if not installed, go hunt Tim down about it). When you open it up... it will look like File:Demo.pdf.

Yes, .hx file is essentially a text file telling Amira what to do... SO, by using that to our advantage, add a line at the very bottom: "source ${AMIRA_ROOT}/share/resources/vrconfig.txt" without the quotation marks. This tells the amira to LOAD UP the file called "VRconfig.txt at the location where Amira is installed within the folder tree /share/resources/.

So, add that, save and exist notepad++.

Now, you told the .hx network file where to load the vrconfig file, you still NEED to make up that txt file to carry out the desired function.

Lucky for you, I am too lazy for pranks so I'll just give you the file here:

Copy these text word for word (watch for spaces):

create HxTracking AmiraVR
AmiraVR config setOptValue 10
AmiraVR fire
proc onKeyF12 {} {
    echo "Switching viewer 0 to mono"
    AmiraVR config setOptValue 10
    AmiraVR fire
proc onKeyF11 {} {
    echo "Switching viewer 0 to stereo"
    AmiraVR config setOptValue 0
    AmiraVR fire